 |
 |
|
|
12-04-2018, 05:48 PM
|
#1 |
 Drives: xp90 1.3l 57 Join Date: Dec 2018
Location: east of uk
Posts: 6
|
p0016 bank 1 sensor a (1.3 L 2NZ-FE)
So whilst exiting a junction, (my car was just about to stall) i had the mil pop on. The code is as above, done 50k and i haven't had time to service it as only just acquired*the car in the last 4 months. After a reset i went for a little drive up the road without any other problems. So i'm thinking it could just have been a glitch in the matrix, a sensor, or the chain may have stretched. Am i right in thinking it will be ok to leave? I don't think it had skipped a tooth as it would still be out now??*
Regards |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2006 Yaris (2NZ -FE 1.3) - P0010 | bung206 | DIY / Maintenance / Service | 3 | 03-19-2018 02:33 AM |
| 2006 Yaris (2NZ -FE 1.3 L) squeaking belt noise | bung206 | DIY / Maintenance / Service | 1 | 06-21-2017 12:48 AM |
| NEED ENGINE CHECK LIGHT CODE LIST | Attitude | Forced Induction Forum | 12 | 04-11-2011 06:38 PM |
Threaded Mode