Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 05-27-2007, 07:21 PM   #1
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
Arrow DIY: Replacing 2-Door Liftback Door Panel Fabric

Heres one for all Yaris polka-dot haters. This DIY is for recovering the interior door panels for your liftback (I would assume its the same process for the sedan but I don't know for sure). This one will take about 3 hours start to finish.

Supplies: Gloves and a can of headliner spray adhesive, and one yard of whatever fabric you wish to recover the door accent panels in (make sure the fabric is thick enough that the glue will not soak through). I chose 3mm thick neoprene for my fabric replacement.

1. Remove both your door panels. Refer to the DIY on Yarisworld for this http://www.yarisworld.com/forums/sho...+panel+removal . Its very easy!!!

2. Remove the plastic window trim piece on the interior of the door panel near the top. Its held on with a few small prongs you can carefully bend to remove this trim piece.

3. Now begin stripping the polka dot fabric off the door panel. Be careful not to rip it because you'll need the entire piece to use as a pattern for your new fabric. Needle nose pliers will help you grab tucked-in pieces where your fingers wont reach. Dont worry about the remaining glue on the door panel unless you want to add another hour to this project removing it.

4. Lay the removed polka dot fabric on your new replacement fabric and cut closely (but not too close) to it to make your new fabric pattern. Dont worry...it doesnt have to be exact! Make note of the tabs on the old fabric and cut these out also (the tabs tuck under the door panel trim to assist in holding the fabric in place. Keep your old polka dot fabric patterns...you never know when you might need them again! NOT.

5. You will have a problem with the trim nearest the rear part of the door. I had to break it loose with a screwdriver to remove this area of fabric. Now I have to drill 3 trim screws (each door) back into it to hold it. No problem. I dont know how you cover this area without breaking this piece free.

6. Spray the exposed fabric area of the door panel with the headliner adhesive. I coated it well but not soaking wet. Allow 5 minutes minumum for sprayed adhesive to become tacky to touch. The adhesive does not bond instantly so you have a little working time with it.

7. Lay your new fabric pattern on the wet adhesive door panel. You get about 2 minutes working time. Press the fabric down and smooth it out on the panel. Make sure you smooth the area immediately by the door handle opening (there is a noticeable ridge there the fabric needs to contour to).

***NOTE: If you are using neoprene like I did there is no need to stretch it, let it lay normally over the door panel. Stretching it will cause stress on the glued area.***

8. Spray interior of door panel and tuck over top of door and side of door, cutting to fit. Tuck corners to hide where trim will cover up. Use adhesive liberally on this step.

9. From the inside of the door panel poke a hole in the door handle cutout and cut the door handle opening leaving enough overlap for the door handle to cover from the inside of the door. DO NOT cut the hole too close to the panel cutout!

10. Test fit door handle trim to ensure fabric coverage all around. Let dry for at least one hour before putting door panels back in car.

11. Clean up any visible adhesive overspray from interior door panel with glue removal product such as 'Goof Off'.

12. Enjoy your non-polka dotted doors!!!! Now cover your seats to match!
Attached Images
File Type: jpg door01.jpg (265.4 KB, 2856 views)
File Type: jpg door01a.jpg (116.9 KB, 2765 views)
File Type: jpg door1ba.jpg (80.8 KB, 2745 views)
File Type: jpg door1bb.jpg (135.6 KB, 2732 views)
File Type: jpg door02.jpg (344.6 KB, 2752 views)
File Type: jpg door03.jpg (285.5 KB, 2726 views)
File Type: jpg door04.jpg (273.7 KB, 2723 views)
File Type: jpg door05.jpg (72.1 KB, 2706 views)
File Type: jpg door06.jpg (254.3 KB, 2719 views)
File Type: jpg door07.jpg (121.1 KB, 2720 views)
__________________
Bringin the Bling to Yarisworld

Last edited by redyaris; 05-27-2007 at 07:39 PM.
redyaris is offline   Reply With Quote
Old 05-27-2007, 07:24 PM   #2
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
Part 2 Pics

Part 2 Pics
Attached Images
File Type: jpg door08.jpg (332.5 KB, 2693 views)
File Type: jpg door09.jpg (253.4 KB, 2663 views)
File Type: jpg door12.jpg (59.2 KB, 2656 views)
File Type: jpg door13.jpg (121.1 KB, 2653 views)
File Type: jpg door14.jpg (208.2 KB, 2650 views)
File Type: jpg door15.jpg (238.7 KB, 2643 views)
File Type: jpg door16.jpg (180.8 KB, 2669 views)
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 05-27-2007, 07:33 PM   #3
OxyG3nE
 
Drives: Toyota Yaris 2007
Join Date: Jul 2006
Location: Montreal , Quebec , Canada
Posts: 373
Send a message via AIM to OxyG3nE Send a message via MSN to OxyG3nE
look really nice ..!! you make me want to do this haha
OxyG3nE is offline   Reply With Quote
Old 05-27-2007, 07:37 PM   #4
brickhardmeat
Lonesome Cowboy
 
brickhardmeat's Avatar
 
Drives: 2007 WHITE HATCHBACK
Join Date: Feb 2007
Location: Inner City, Dallas
Posts: 2,995
Thumbs up

Nice, I gotta get some black pleather. I'm going vegan leatherette interior.
__________________
SPONSORED BY
brickhardmeat is offline   Reply With Quote
Old 05-27-2007, 07:45 PM   #5
kurokoma-kun
 
Drives: 2007 Yaris HB
Join Date: Apr 2007
Location: my own little world
Posts: 1,256
Redyaris, that is beautiful! The neoprene looks awesome even better than my suede I think (which I have still not finished )

Great DIY too! I'm sure it will be appreciated...

Last edited by kurokoma-kun; 05-27-2007 at 07:56 PM.
kurokoma-kun is offline   Reply With Quote
Old 05-27-2007, 07:49 PM   #6
uncleyaris
 
Drives: 2007 Bayou Blue!!!!!!!
Join Date: Nov 2006
Location: Toronto
Posts: 1,523


great job, congrats! looks great.
uncleyaris is offline   Reply With Quote
Old 05-27-2007, 07:56 PM   #7
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
Quote:
Originally Posted by brickhardmeat View Post
Nice, I gotta get some black pleather. I'm going vegan leatherette interior.
No bovines were killed for this DIY!
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 05-27-2007, 08:01 PM   #8
brickhardmeat
Lonesome Cowboy
 
brickhardmeat's Avatar
 
Drives: 2007 WHITE HATCHBACK
Join Date: Feb 2007
Location: Inner City, Dallas
Posts: 2,995
ha, maybe fish scale interior

neoprone looks nice I hope it holds up in the heat and sun well

did you find the stretchy quality of this fabric made the install easier?
__________________
SPONSORED BY
brickhardmeat is offline   Reply With Quote
Old 05-27-2007, 08:05 PM   #9
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
Now I have to get the windows tinted!!!!

Btw, I have enough neoprene left over to cut pads for the front storage bins and wrap my factory armrest too.

Hmmm, never noticed how much the polka dots looks like a dress my wife owns.
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 05-27-2007, 08:18 PM   #10
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
The stretchiness did make it easier but as I noted if you use neoprene DO NOT stretch it. Let it lay normally over the door panel. Stretching it will cause stress on the glue causing the neoprene not to contour properly....and the fabric will become thinner causing rips and holes.
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 05-27-2007, 08:20 PM   #11
ChinoCharles
Banned
 
Drives: LB
Join Date: Jul 2006
Location: OH
Posts: 7,787
Hey redyaris... hats off man! What a difference! This is definitely one of my favorite DIY's to date, and its obvious you took great care doing a perfect job the first time! Congratulations and thanks!
ChinoCharles is offline   Reply With Quote
Old 05-27-2007, 10:12 PM   #12
Doc Zaius
Lurker supreme!
 
Doc Zaius's Avatar
 
Drives: old and boosted!
Join Date: Nov 2006
Location: Ottawa, ON, Canada
Posts: 792
Hey redyaris! Looks really good... I'm very impressed with the finished product! The TRD badges are a nice touch too.
__________________
2006 Red Blitzed RS 5-door
Doc Zaius is offline   Reply With Quote
Old 05-27-2007, 10:30 PM   #13
death is my gift
wacky broadway nightmare
 
death is my gift's Avatar
 
Drives: Willow is a '07 Red Yaris LB
Join Date: Apr 2007
Location: dallas
Posts: 621
Send a message via AIM to death is my gift Send a message via MSN to death is my gift Send a message via Yahoo to death is my gift
i'm so jealous of YOUR red yari. so so nice dude.
__________________
"it's always complicated and at some point someone has to draw the line and that is always going to be me. you get down on me for cutting myself off but in the end the slayer is always cut off" Buffy
death is my gift is offline   Reply With Quote
Old 05-27-2007, 10:59 PM   #14
Black Yaris
der Zeck
 
Black Yaris's Avatar
 
Drives: '05 Audi A4 1.8t quattro
Join Date: Sep 2006
Location: Toledo, OH
Posts: 5,231
Looks killer, I have been pondering if and when I was going to do this, I was just wondering what I would be getting into, and thanks to you nicely written DIY my problem is solved... they realy turned out nice, when I herd you say neoprene, I thought it was going to look god awful, but is is realy sharp.... any pix of the back?
__________________
Black Yaris is offline   Reply With Quote
Old 05-28-2007, 09:41 AM   #15
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
Thanks people!!!
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 05-28-2007, 08:44 PM   #16
slothman86
 
slothman86's Avatar
 
Drives: 07 Yaris Liftback
Join Date: Feb 2007
Location: Savannah, GA
Posts: 733
great diy! how about the headliner and maybe even the dash board?
__________________
INDUSTRIAL DESIGN - DEVIANTART - CARDOMAIN
slothman86 is offline   Reply With Quote
Old 05-29-2007, 10:21 AM   #17
redyaris
Shiny Chromey Coolness
 
redyaris's Avatar
 
Drives: 2007 Toyota Yaris Liftback
Join Date: Feb 2007
Location: Orlando, FL
Posts: 982
The factory headliner is ok for me...cover the dash in fabric???? EEK.
__________________
Bringin the Bling to Yarisworld
redyaris is offline   Reply With Quote
Old 03-18-2009, 12:41 AM   #18
manlyyaris
 
manlyyaris's Avatar
 
Drives: USDM white liftback
Join Date: Oct 2008
Location: SoCal
Posts: 53
Thanks alot! this is amazing!
manlyyaris is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:59 PM.




YarisWorld
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.