|11-20-2016, 06:09 AM||#1|
I've made a post!
Join Date: Feb 2015
projector retrofit DIY wiring issue
Recently, I made DIY a projector lens for my headlight which is 9003 to singal H1 bulb
I tired to use the HID low beam wire to low beam(+ -) and retrofit reflector + to high beam
I realized that when I turn on high beam switch, there is no power to low beam, so the retrofit reflector is on but no light from low beam (no any light)
Therefore, I tired to use 4 pin relay, 86 to high beam switch from original socket source, 85 to battery - , 30 to battery +, and 87 to low beam wiring.
When I turned on the high beam, the low beam wire(20awg) smoked and burnt.
Also, all 4 pin wire are 16 awg
Did I do something wrong?
Is there any other way to make it works except making a switch for retrofit reflector?
|9003 to h1, diy, wiring|
|Thread||Thread Starter||Forum||Replies||Last Post|
|DIY Cruise Control FAQ (2006-2010 Yaris)||CTScott||DIY / Maintenance / Service||440||01-22-2017 09:48 PM|
|Remote Start DIY Wiring Guide 2006-2010 Yaris||CTScott||DIY / Maintenance / Service||258||10-25-2016 11:08 AM|
|diy HID projector w/ halo headlight install||tmontague||DIY / Maintenance / Service||17||02-04-2016 12:34 PM|
|Relay Wiring for DIY LED Daytime Running Lights (DRL)||zuberio||DIY / Maintenance / Service||20||07-07-2011 08:02 PM|
|Two DIY wiring requests.||Midnight Drifter||DIY / Maintenance / Service||1||03-03-2011 10:05 AM|