|
11-26-2018, 05:04 PM | #19 |
Drives: 2000 SCP10, 2001 NCP13 Join Date: Jul 2016
Location: CZ
Posts: 54
|
Resurrecting this thread, because I'll soon need to get the engine out of my NCP13 T-Sport in order to replace a part of the passenger-side frame rail and change the main seals and a few other things while I'm there.
My question is, can I also pull it out all at once like that? And if so, what do I need to remove (on the subframe/engine)? I think it's the 4 bolts holding the subframe to the chassis, the bottom of the struts, the exhaust manifold, then any sensors/wires/vacuum lines and it should be free, right? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wtb subframe for an 07 lb | marlondog | Willing to Buy by private party | 2 | 10-14-2013 02:51 PM |
Official: Toyota dropping the Matrix after 2013 (from U.S.) | Kal-El | Off-topic / Other Cars / Everything else Discussions | 10 | 08-09-2013 08:49 AM |
Dropping out of boost/not activating | 47_MasoN_47 | Forced Induction Forum | 13 | 05-06-2013 05:26 PM |
MPG Dropping | NRclem | Fuel Economy Forum | 20 | 01-07-2013 12:39 PM |
need to tighten subframe..? | TickleTimeTim | DIY / Maintenance / Service | 1 | 06-26-2012 01:55 PM |