|
06-28-2013, 12:47 PM | #1 |
Drives: Yaris Sedan Join Date: Jun 2013
Location: Algeria
Posts: 2
|
How to tighten handbrake cable? (Yaris Sedan)
I have a Toyota Yaris Sedan, and the handbrake cable is too loose.
Can anyone show me how to proceed to tighten it? Thanking you in advance. |
06-28-2013, 06:11 PM | #2 |
Drives: Yaris HB Join Date: Jul 2007
Location: Central Alabama, GOD BLESS AMERICA
Posts: 755
|
Remove rear wheels.
Do not remove the brake drum when doing this procedure. Locate and remove a rubber grommet on the rear of the drum bracket. It is on top, very near the bleeder valve. Stick something in there, like a flat screw driver, and push in to "click" the star wheel alignment adjuster. It sets the brake shoes a little closer to the drum, so the slack on your parking brake disappears. It also ensures the shoes are positioned to apply even pressure to the drum, so they wear evenly and work as they should. Click 2 clicks at a time, and try to spin your drum by hand. After 4-5 clicks it should be harder to move freely, and you want to continue clicking the little wheel until it becomes almost impossible to move the drum by hand. You cannot remove the drum anymore once you've tightened it - it will take a few thousand miles of wear. Reinstall grommet, and reinstall wheels. |
06-28-2013, 08:48 PM | #3 |
Drives: Yaris Sedan Join Date: Jun 2013
Location: Algeria
Posts: 2
|
Thank you Swidd for the reply.
|
01-04-2018, 07:15 AM | #4 |
Drives: 2007 Toyota Yaris Sedan Join Date: Jun 2017
Location: Nova Scotia
Posts: 2
|
Hi guys, I had a quick question regarding the hand brake. My hand brake in my 2007 Yaris Sedan is really high, and barely holds the car on a slope. I have had the shoes and hardware replaced, however nothing else. Before I attempt to adjust it as mentioned above, could there be other parts that should be replaced (Wheel cylinder for example)?
Thanks! Newb |
01-04-2018, 09:09 AM | #5 |
Drives: '08 2zr swapped Vios M/T Join Date: Oct 2012
Location: Caledonia Ont.
Posts: 2,938
|
I wouldn't recommend replacing the cylinder unless your current one is leaking. I always remove the drum to adjust the adjuster as I find it a huge pita to access through the hole in the back. I typically adjust the start adjuster by about 3 clicks at a time and stop when it is slightly difficult to put the drum back on. The drum should spin about a half to 3/4 turn on its own.
In my experience this allows about 1-3 clicks of the e brake for full engagement and it will slightly loosen up in the next 100km or so of driving. I always re adjust my rear brakes when I can get 4-5 or more clicks of the e brake. This is typically every 6 months or after a day at the track.
__________________
No one ever wants to give a Yaris the point by... |
01-04-2018, 10:55 AM | #6 |
Drives: 2007 Toyota Yaris Sedan Join Date: Jun 2017
Location: Nova Scotia
Posts: 2
|
Thanks for that! I was looking online to possibly purchase the parts. I will have it looked at for sure.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW | VitzBoy | General Yaris / Vitz Discussion | 7 | 09-20-2023 07:50 AM |
Consumer Reports Is On Crack!!! | doublewam | General Yaris / Vitz Discussion | 82 | 05-07-2011 11:03 AM |
2007 Yaris Pricing Info ! | YarisBueller | New YARIS Purchase Forum | 104 | 06-24-2009 04:54 PM |
yaris Advance Sedan | Rudeshady | Central and South America | 14 | 06-25-2007 01:50 AM |