NST Pulley Kit and modded 1ZZ throttle body - Toyota Yaris Forums

rpster · 10-16-2023, 10:40 PM

NST Pulleys for 1NZ-FE - Crank and Alternator. Water pump pulley SOLD Used for about 10k miles, light wear and scratches from use. Normally $210 New from NST. Asking $100 obo + shipping

Modded 1ZZ Throttle Body. Has the following mods to work in a Yaris with a 1NZ-FE, ready to drop in!:

1NZ-FE control board
Adjusted minimum valve opening to resolve high idle
Custom CNC adapter plate - allows use of stock intake gasket
Rotated coolant ports to fit Yaris hoses

Asking $80 obo + shipping

Calrenman · 11-01-2023, 06:57 AM

Hello. Would you consider selling just the water pump Pulley?

Has the adjustment bolt for the 1ZZ been exposed? Is that how it was adjusted?

Thanks

rpster · 11-01-2023, 02:00 PM

I'll ask $50 for the water pump pulley

Yes, I removed the epoxy plug and had to grind a flat into the set screw to adjust the idle since it was stuck in place. After adjustment, it was sealed with SteelStik epoxy. It should be easier to remove this time with a pick.

10-16-2023, 10:40 PM	#1
rpster Drives: '07 Yaris Liftback Join Date: Jul 2007 Location: Bay Area, CA Posts: 38	NST Pulley Kit and modded 1ZZ throttle body NST Pulleys for 1NZ-FE - Crank and Alternator. Water pump pulley SOLD Used for about 10k miles, light wear and scratches from use. Normally $210 New from NST. Asking $100 obo + shipping Modded 1ZZ Throttle Body. Has the following mods to work in a Yaris with a 1NZ-FE, ready to drop in!: 1NZ-FE control board Adjusted minimum valve opening to resolve high idle Custom CNC adapter plate - allows use of stock intake gasket Rotated coolant ports to fit Yaris hoses Asking $80 obo + shipping Last edited by rpster; 12-28-2023 at 11:59 AM.

11-01-2023, 06:57 AM	#2
Calrenman Drives: 2015 Toyota Yaris LE Hatchie Join Date: Oct 2021 Location: So. Cal. Ventura Posts: 91	Hello. Would you consider selling just the water pump Pulley? Has the adjustment bolt for the 1ZZ been exposed? Is that how it was adjusted? Thanks

11-01-2023, 02:00 PM	#3
rpster Drives: '07 Yaris Liftback Join Date: Jul 2007 Location: Bay Area, CA Posts: 38	I'll ask $50 for the water pump pulley Yes, I removed the epoxy plug and had to grind a flat into the set screw to adjust the idle since it was stuck in place. After adjustment, it was sealed with SteelStik epoxy. It should be easier to remove this time with a pick.