|
04-11-2013, 08:39 PM | #1 |
DIY how to change you belt in 10 minutes without breaking VVTI solenoid
So before I start the tools you will need are a 12mm socket or long handle ratcheting wrench, and a 14mm as well as a long prybar
The belt I recommend buying is bando. Part number if you need is in the picture below. And before doing anything mark the location of your alternator to the bracket as shown below. This prevents error of over tightening your belt which can cause premature failure of your water pump or having it too loose which can cause squealing and potential for belt to fall off. Loosen the top 12mm bolt a few turns and then the bottom 14mm bolt of the alternator and push it back as far is it will allow and slip off the old belt. For comparison this is how bad my old belt look compared to new at 50k miles. Installing the belt is fairly strait forward incase you didnt pay attention to how it came off follow the diagram below. When tightening the belt gently pry the alternator against the engine on the LEFT side of the bracket. Doing so to the right risks accidentally prying against the VVTi solenoid and breaking it. Make sure the alternator lines up to mark you made. If you accidentally forgot to make a mark or just want to double check the belt is tightened correctly find a point where you can gain access to belt and in the center pinch it and turn it, it should turn about halfway. And there you have it with basic tools it can be done on your drive way in about 10 minutes.
__________________
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Yaris Oil Change DIY | rningonfumes | DIY / Maintenance / Service | 91 | 01-11-2019 07:18 PM |
DIY: CHANGE MANUAL TRANNY OIL | ttufrosty | DIY / Maintenance / Service | 157 | 09-07-2018 01:43 PM |
DIY (08' USDM LB): Interior Light Color Change | revnull | DIY / Maintenance / Service | 37 | 05-21-2016 12:59 PM |
diy for steering wheel change | aucorium | Cosmetic Modifications (Exterior/Interior) | 64 | 06-21-2010 08:46 AM |
First DIY oil change but... | derickveliz2 | DIY / Maintenance / Service | 31 | 02-02-2009 11:36 AM |