|
02-23-2014, 03:06 AM | #1 |
Drives: yaris Join Date: Jan 2014
Location: -
Posts: 5
|
[HELP] Dropped knife into centre console
Was pulling apart the centre console and dropped my knife into the part which falls into the middle panel which has the gears and handbrake. What do i need to undo the bolt on it ? just a torque wrench ? what happens if it fell further down is it a possible hazard?
thanks |
02-23-2014, 04:36 AM | #2 |
Drives: 2007 Toyota Yaris Hatchback Join Date: Sep 2012
Location: Las Vegas, NV
Posts: 323
|
In the center console, behind the e-brake, there should be a cup holder. If I remember correctly, you only need a screw driver. Once you remove the screw, you can lift the center plastic up. I don't see it causing any problems if kept there, but someone may find treasure if you ever sell the car =].
Edit: I changed the bolt into a screw for easier access. I just used a interchangeable wrench to take off the bolt. |
02-23-2014, 04:14 PM | #3 |
Drives: yaris Join Date: Jan 2014
Location: -
Posts: 5
|
Undid the bolt and now have a problem lifting the plastic piece over the hand brake :P keeps getting hooked. any tips?
|
02-23-2014, 04:34 PM | #4 |
Embracing Curves
Drives: '14 Prius Executive Join Date: Aug 2013
Location: mid-western Germany
Posts: 256
|
Gently lift its front end upwards.
Be careful not to break the clips - I'll cross my fingers ;) |
02-23-2014, 04:38 PM | #5 |
Drives: 2007 Toyota Yaris Hatchback Join Date: Sep 2012
Location: Las Vegas, NV
Posts: 323
|
You have to unclip the smaller plastic piece near the ebrake - pop it out. Afterwards, you can raise the center plastic by the back and move the ebrake in position.
|
02-23-2014, 07:39 PM | #6 |
Drives: yaris Join Date: Jan 2014
Location: -
Posts: 5
|
DONE :D TY
|
|
|