How do I wire up buzzers to rear indicators?

[alang200]

Originally Posted by bizarro

I put a link in my original post above.

Thanks for reply I also found link by Hartside very helpful also - Thanks

[Hartside]

Just be aware that that link from me was for a flasher that would not fit the Yaris

[Hartside]

PS - I just checked the live wire to the indicators and the green is the live wire on the front indicators only

I bought this the other day and will fit it into the rear flasher circuit over the next couple of weeks. It is dead simple, orange wires to the live feed on each side and the black to a solid earth point. I tried it last night on a battery and the buzzer is just the right loudness, once tucked away behind some plastic trim it will be just about right.

http://cgi.ebay.co.uk/INDICATOR-WARN...QQcmdZViewItem

Update
I've just been back out today and checked out the rears and the live feed to the indicator is on the large multiblock at the bottom of your picture (The one with lots of fine wires going in) The live feed on the right rear as you face it is the fine yellow wire, on the left it is the light green one - hope this helps

[bizarro]

Very useful colour diagram of the flash relay in this document here - pages 124-125

[alang200]

Thanks for response and info about the source of 'indicator sound enhancement adaptors', which I am ordering, however a manufacturers variable indicator sound level control would be a valued feature on Yaris. Perhaps it is a problem on other cars in Toyota range?