Add remote to factory keyless.

[CTScott]

Originally Posted by Nodrog

In the Owner's Manual that I got online from Toyota, it has these three FCC IDs, one in the section of the immobilizer key (which I don't have), and two in the section for the regular key. I thought I had read on here somewhere that one of two was the key and the other was the receiver in the car. The two IDs are MOZB41TG and MOZB21RG. I took the cover off the new key, and the FCC ID is MOZB41TG.
It would appear to be correct, yet I cannot get it to program.... :(

At this point, I think I would pop the driver's side C pillar to verify that the receiver is really there.

[Nodrog]

Originally Posted by CTScott

At this point, I think I would pop the driver's side C pillar to verify that the receiver is really there.

Thanks CTScott. I've been on vacation for 2 weeks without the car, and I just got back and tried the programing again. Still did not work.
Ok, so if I pull the C pillar what will the receiver look like? And is popping off the C pillar easy?
Thanks!

[CTScott]

Originally Posted by Nodrog

Thanks CTScott. I've been on vacation for 2 weeks without the car, and I just got back and tried the programing again. Still did not work.
Ok, so if I pull the C pillar what will the receiver look like? And is popping off the C pillar easy?
Thanks!

It is a small black module, about 3"x3"x1" and will say Receiver, Door Control" on it.

I haven't removed one on a sedan, but it looks like there are 4 clips that hold it on.

[Nodrog]

Originally Posted by CTScott

It is a small black module, about 3"x3"x1" and will say Receiver, Door Control" on it.

I haven't removed one on a sedan, but it looks like there are 4 clips that hold it on.

Here are pics of what I found behind the driver's C pillar...I'm going to assume the dangling white plug is what WOULD be connected to the remote receiver, which appears to not be there. Is this a pretty good assumption?

[CTScott]

Originally Posted by Nodrog

Here are pics of what I found behind the driver's C pillar...I'm going to assume the dangling white plug is what WOULD be connected to the remote receiver, which appears to not be there. Is this a pretty good assumption?

That looks correct. 5 pin connector with 4 pins used. Red, blue, white and white/black wires.