Valve lifter Problem !!!

[Patocine]

I have a New Yaris Sedan 2007.

The stock has 16 valve lifter.
Like that;

these were removed and not installing them.

Each Valve Lifter has a number. ( 34,36,38,41,42 )

after install ,It sounds a harmonized and tac tac tac, is the valve.

As I can know the position of each Valve Lifter.

Thank you.

[CTScott]

The lifters are available from Toyota in 35 sizes ranging from 5.060 to 5.740 mm.

Look at the "Engine Mechanical" section of the service manual in the link below and start around page EM-13 for information on how to determine the correct lifter thickness for each valve:

http://www.microimageonline.com/foru...32-YARIS-FILES

[Patocine]

Originally Posted by CTScott

The lifters are available from Toyota in 35 sizes ranging from 5.060 to 5.740 mm.

Look at the "Engine Mechanical" section of the service manual in the link below and start around page EM-13 for information on how to determine the correct lifter thickness for each valve:

http://www.microimageonline.com/foru...32-YARIS-FILES

Thanks 4 u Reply but.

I do not understand the manual.

I have the following Valve Lifter

Number Cant.
Lifter

32 x 1
34 x 3
36 x 1
38 x 3
39 x 1
41 x 6
42 x 1

how to install ?

Thanks.

[Viperoni]

The valves are sized differently depending on the clearance in each lifter "pocket" in the cylinder head. This is how the valve lash is changed/adjusted.

You need to fit the correct sized lifter into the pocket.
The numbers on the lifters do not tell the order or sequence that they need to be installed, only the size.

You need to measure each lifter and put it into the correct pocket.

[Patocine]

Originally Posted by Viperoni

The valves are sized differently depending on the clearance in each lifter "pocket" in the cylinder head. This is how the valve lash is changed/adjusted.

You need to fit the correct sized lifter into the pocket.
The numbers on the lifters do not tell the order or sequence that they need to be installed, only the size.

You need to measure each lifter and put it into the correct pocket.

And how i know , the correct measure for each pocket ?

Thanks.

[CrankyOldMan]

Maybe we could get someone who speaks Spanish to help?

Did you measure the valve clearances before removing the lifters? If not, you will have to try different combinations to get the right valve clearance:

Originally Posted by Page EM-9, step 8(d)(1)

Using a feeler gauge, measure the clearance between the valve lifter and camshaft.

Valve clearance (cold):
for intake:

0.15 to 0.25 mm (0.006 to 0.010 in.)

for exhaust:

0.25 to0.35 mm (0.010 to 0.014 in.)

That means installing the lifters and cams again and starting over.

[Patocine]

Originally Posted by CrankyOldMan

Maybe we could get someone who speaks Spanish to help?

Did you measure the valve clearances before removing the lifters? If not, you will have to try different combinations to get the right valve clearance:


That means installing the lifters and cams again and starting over.

Tienes razon lo mejor seria que me explicara alguien en español.


It has been very helpful post.

thanks