Dabuu's NCP131 - Toyota Yaris Forums

Dabuu · 03-17-2017, 11:16 PM

Much excite!

DCSports Header, 73mm to 54mm hubcentric rings, and my new static cling numbers. :)

I usually don't run hubcentric rings, but I'm tired of seeing the rust in the hubs since I don't run center caps. I'm planning to clean up the hubs/axle stubs and spraying a coat of black, to make it all purdy. :P

Running my old 319 number that I used to use in Autox. I did have a set of the 503's that I HAD to buy at an event many years ago, but one flew off that same event, fml. Since the new ones are static cling, I am going to put painters tape along the edges.

Headers, nuff said. HPS intake is also on the way. ;)

03-17-2017, 11:16 PM	#11
Dabuu Radical Dreamer Drives: spiritedly. Join Date: May 2016 Location: No Bueno Park, CA Posts: 219	Much excite! DCSports Header, 73mm to 54mm hubcentric rings, and my new static cling numbers. :) I usually don't run hubcentric rings, but I'm tired of seeing the rust in the hubs since I don't run center caps. I'm planning to clean up the hubs/axle stubs and spraying a coat of black, to make it all purdy. :P Running my old 319 number that I used to use in Autox. I did have a set of the 503's that I HAD to buy at an event many years ago, but one flew off that same event, fml. Since the new ones are static cling, I am going to put painters tape along the edges. Headers, nuff said. HPS intake is also on the way. ;) __________________ Enjoy Family Car Sports

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NCP91 (Second Gen Yaris) Strut Bar fits on NCP131 (Third Gen Yaris)	cwk8412	Third Gen Yaris General Discussion	8	06-20-2017 07:05 PM
FYI: Aftermarket parts from Japan (NCP131)	yarisugi	Third Gen Yaris General Discussion	26	01-30-2016 06:43 AM
Toyota Vitz RS 1.5 NCP131	Nas_RS	DIY / Maintenance / Service	5	02-24-2015 04:27 AM
ncp131 yaris DIY DVD is out yaay	enviri	Third Gen Yaris General Discussion	0	01-17-2012 11:53 PM