Toyota Yaris Forums - Ultimate Yaris Enthusiast Site - Herbicidal's Album: Sound deadening my 08' S sedan.

Toyota Yaris Forums - Ultimate Yaris Enthusiast Site

		Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Herbicidal's Profile > Albums
Sound deadening my 08' S sedan.

The Tire Rack

Page 2 of 3

2

Sound deadening my 08' S sedan.

Deadened the license plate and frame with scraps of RAAMmat and Ensolite. Don't throw your scraps away!

Reassabled the trunk area after installing the rear speakers. The new ones sound great!

Put some extra Ensolite on the back of the plate where it may touch the car during extreme base. :biggrin:

Speaker adapters.

Several places I deadend the "C" pillar panels since there was stuff in the way on the body of the car.

Looks like a giant Jiffy Pop popcorn container!

98% done with rear as far as RAAMmat is concerned. I'm pretty well protected from aliens reading my brain waves, as long as I'm in the trunk.

Right rear wheel well done, plus just about all the rear speaker deck. I may put some Ensolite on the wheel wells, have fully decided yet.

New Alpine Type R rear speakers. Ya baby!

New Kicker door speakers with electronic crossover and tweeters.

Left rear "C" pillar panel removed. Both rear speakers removed.

Right rear "C" pillar panel removed. Notice the stock speaker sitting there...where's the magnet?!?

A semi-closeup of the rear deck minus the deck material, etc. The speakers are reflecting in the rear window. All of that bare metal I want to...

From the front seats looking toward the back. You can see the left wheel well that I want to deaden too.

Inside the car looking towards the trunk. The rear deck topper and the factory sound deadener is flopped over on the right.

Now I can pretty much work up to the back of the front seats.

Rear seat, subframe and wheel well panels removed. You can see where I stopped from the trunk.

Inside the car, facing the left rear corner, taking the picture from behind the passenger side front seat. I've finally uncovered the wheel wells!

Trunk, passenger side.

Pretty much done with the trunk at this point. This is the drivers side.

Trunk and deck lid about 95% done at this point.

RAAMmat in the trunk lid.

Figured out an easier way to remove those, those, pluggy, clippy things. A ziptie fits through the head and now you can pull them out with out...

I used the leftover backing for template material.

Partially done trunk. Right hand side.

Page 2 of 3

2

All times are GMT -4. The time now is 11:19 AM.