 |
 |
|
|
12-06-2008, 04:24 PM
|
#1 |
|
Reluctantly Crouched...
Drives: 2008 Yaris HB M/T Join Date: Oct 2008
Location: DFW, TX
Posts: 867
|
TRD Springs issue
I just installed my TRD lowering springs, and cut the bumpstop by 1" (the lower portion), and everything went together smoothly, but I'm getting a bit of rub on the drivers side under somewhat-hard cornering (<20mph). I have 215-40-17" on a 40mm offset, which is pretty standard on these, and everyone said there would be no rub, so I'm a bit surprised. Is this a bad spring, or an issue that will resolve when the alignment is corrected?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tanabe nf210 vs. TRD lowering springs?? | static808 | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 37 | 01-24-2012 12:00 AM |
| Are my trd springs installed upside down? | YarisSedan | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 12 | 11-18-2008 12:12 AM |
| Question about 2 kinds of TRD springs & rear strut bar | Astroman | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 3 | 06-18-2007 06:44 PM |
| NF210 versus TRD springs | nurburgring | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 8 | 04-01-2007 05:30 PM |
| HOLEY COW 674.75 to install TRD lowering springs | dbaxter | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 11 | 08-09-2006 01:40 PM |
Threaded Mode