Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > Cosmetic Modifications (Exterior/Interior)
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 09-16-2009, 08:01 PM   #1
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Question about lexan windows on the liftback

I'm planning on making my own lexan rear windows for an 09 liftback and I was wondering if they would would need to be pre molded with a curve in them before re-adhering them back to the framing. My idea was to trace the windows on paper as a mock up then cut the sheets of lexan accordingly. My logic was that because lexan is flexible i could just bend it to fit the window frames however I'm sure I could be completely dead wrong Anyone know if that's possible or would I need custom shaped pieces to fit properly?
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-16-2009, 09:43 PM   #2
PHXDEMON
 
PHXDEMON's Avatar
 
Drives: 2007 Red Liftback
Join Date: Oct 2008
Location: Phoenix, AZ
Posts: 885
Lexan is very flexible so you should be fine. Only thing that sucks is that it scratches so easily.
PHXDEMON is offline   Reply With Quote
Old 09-17-2009, 12:10 AM   #3
Brian
 
Brian's Avatar
 
Drives: '07 Yaris turbo, '11 Juke
Join Date: Mar 2007
Location: Riverside, CA
Posts: 849
When I had my truck about 5 years ago I swapped out all the windows including the windshield
for lexan. It came with a protective coating on it to resist scratching. I ordered them from a
company online that specializes in lexan windows. I wish I could find the website again cause
It only cost me about $1000 for all the windows. If you look on selectproducts.com they sell a
plexiglass bender or you can slowly heat it to get a slight curve out of it.
Brian is offline   Reply With Quote
Old 09-17-2009, 02:28 AM   #4
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Quote:
Originally Posted by kustom play View Post
there used to be this place called speed glass

but yea lexan scratches super easy and I have a good feeling on a DD it would yellow after a while
My plan was to have it tinted on the inside and out before installing it thus making it fade and scratch resistant! Thank you for your help I will be sure to post photos of the completed project and maybe even sell completed pieces if it all works out
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-17-2009, 05:31 AM   #5
ezhacker1
 
ezhacker1's Avatar
 
Drives: Decepticon - Ravage
Join Date: Nov 2008
Location: San Francisco
Posts: 1,464
are you going for shatter resistant windows?
__________________


Check out my Build thread:
http://www.yarisworld.com/forums/showthread.php?t=52274
ezhacker1 is offline   Reply With Quote
Old 09-17-2009, 10:23 AM   #6
Mouse
 
Drives: 2007 MX5
Join Date: Feb 2009
Location: Miami, Fl.
Posts: 338
It's for a weight savings
Mouse is offline   Reply With Quote
Old 09-17-2009, 10:47 AM   #7
Tamago
 
Tamago's Avatar
 
Drives: UZJ100
Join Date: Dec 2006
Location: Off Grid
Posts: 4,922
question:

do you still have your air conditioning and stereo?
__________________
Been a long time messing with cars..
Tamago is offline   Reply With Quote
Old 09-17-2009, 11:10 AM   #8
Nexus1155
Bathroom + Laptop = <3
 
Drives: Audi
Join Date: Aug 2006
Location: Dorchester
Posts: 1,009
Send a message via AIM to Nexus1155
No, but seriously.... is this for weight savings because unless everythign is gutted, you are doing the wrong thing first..

"More than you can afford buddy..... Ferrari"
Nexus1155 is offline   Reply With Quote
Old 09-17-2009, 11:11 AM   #9
Tamago
 
Tamago's Avatar
 
Drives: UZJ100
Join Date: Dec 2006
Location: Off Grid
Posts: 4,922
power window regulators + lexan is pimp!
__________________
Been a long time messing with cars..
Tamago is offline   Reply With Quote
Old 09-17-2009, 11:41 AM   #10
Sodium Duck
╚══════════RN
 
Sodium Duck's Avatar
 
Drives: 2008 Liftback
Join Date: Oct 2008
Location: Western Mass.
Posts: 999
Send a message via AIM to Sodium Duck
Interesting project, post pics if you do this!
__________________
42.88
Sodium Duck is offline   Reply With Quote
Old 09-17-2009, 11:46 AM   #11
Tamago
 
Tamago's Avatar
 
Drives: UZJ100
Join Date: Dec 2006
Location: Off Grid
Posts: 4,922
Quote:
Originally Posted by Sodium Duck View Post
Interesting project, post pics if you do this!
it already looks a lot like this:

__________________
Been a long time messing with cars..
Tamago is offline   Reply With Quote
Old 09-17-2009, 01:22 PM   #12
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Quote:
Originally Posted by Nexus1155 View Post
No, but seriously.... is this for weight savings because unless everythign is gutted, you are doing the wrong thing first..

"More than you can afford buddy..... Ferrari"
The car is completely gutted including radio and AC....hell I even pulled out my side curtain airbags and cut off the roof mounts that they used to be attached to Basically anything that could be removed from inside of the car that didn't affect its structural integrity and didn't cost a fortune to remove is now gone. So to answer your question, yes this is for weight savings
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-17-2009, 01:23 PM   #13
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Quote:
Originally Posted by Tamago View Post
question:

do you still have your air conditioning and stereo?
Negative they are both gone
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-17-2009, 01:42 PM   #14
ezhacker1
 
ezhacker1's Avatar
 
Drives: Decepticon - Ravage
Join Date: Nov 2008
Location: San Francisco
Posts: 1,464
well if you go ahead with lexan all around besides lightweight you would have good protection from thieves then again it'll be a death trap if you need to break the glass to get out.
__________________


Check out my Build thread:
http://www.yarisworld.com/forums/showthread.php?t=52274
ezhacker1 is offline   Reply With Quote
Old 09-17-2009, 02:09 PM   #15
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Quote:
Originally Posted by ezhacker1 View Post
well if you go ahead with lexan all around besides lightweight you would have good protection from thieves then again it'll be a death trap if you need to break the glass to get out.
I'm leaving the front windows as is for two reasons!
A. So I can still get out of the car in an emergency
B. So i don't suffocate to death from burning plastic if my engine happens to catch on fire
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-17-2009, 02:11 PM   #16
Tamago
 
Tamago's Avatar
 
Drives: UZJ100
Join Date: Dec 2006
Location: Off Grid
Posts: 4,922
and your purpose for destroying a 2009 yaris is? better handling? faster 1/4mile times? your logic amuses me so far, i want to hear why you're doing all this.
__________________
Been a long time messing with cars..
Tamago is offline   Reply With Quote
Old 09-17-2009, 03:06 PM   #17
arcticvitz
 
arcticvitz's Avatar
 
Drives: Base 09 White Yaris 3DR 5MT
Join Date: Mar 2009
Location: Studio City, CA
Posts: 107
Send a message via AIM to arcticvitz
Quote:
Originally Posted by Tamago View Post
and your purpose for destroying a 2009 yaris is? better handling? faster 1/4mile times? your logic amuses me so far, i want to hear why you're doing all this.
I'm going to answer that question as if it were positive and not passive aggressive (can't quite tell really). "Destroying" is a relative term in the sense that to you it may seem like I am ruining a brand new car where as to me I'm simply adjusting it to suit my liking. All of us on this forum have an idea as to what our car should be in the end, many people probably think you "Destroyed" your Xa by painting it panda color and putting a turbocharger on it but that's exactly what YOU wanted and not anyone else. Isn't that what car customization is all about?

My logic when I first began tearing the interior of my car apart was that I wanted to turn an otherwise mild mannered econo-box into a true competitor at the track as well as an exhilarating weekend canyon car. Although I may not have the budget for a new motor and a custom turbo kit, I can afford to be creative and think of cheap yet effective ways of improving overall driving performance even if that means eliminating certain comforts like air conditioning and sound insulation materials. In conclusion, yes this is all about better handling and overall performance on a budget! Well, that and possibly to inspire others to appreciate their car and realize that the only limitations are one's own imagination. I guess I'm just a little more extreme than others?
__________________
Proud to purchase parts through
arcticvitz is offline   Reply With Quote
Old 09-17-2009, 03:30 PM   #18
ezhacker1
 
ezhacker1's Avatar
 
Drives: Decepticon - Ravage
Join Date: Nov 2008
Location: San Francisco
Posts: 1,464
well if hes gonna keep the windshield as glass, then im cool with it. least its not a death trap anymore. Thieves will have a harder time breaking lexan.
__________________


Check out my Build thread:
http://www.yarisworld.com/forums/showthread.php?t=52274
ezhacker1 is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Florida Yaris Roll Call: Part 3- Post Hacking! Sabretooth Southeast 81 05-22-2009 10:39 AM
Question for LB owners with windows tinted myt Cosmetic Modifications (Exterior/Interior) 13 08-10-2007 12:44 PM
a question for those with tinted windows... static808 Cosmetic Modifications (Exterior/Interior) 52 02-08-2007 10:42 PM
Liftback seat question Goose General Yaris / Vitz Discussion 6 04-21-2006 12:29 PM


All times are GMT -4. The time now is 10:51 PM.




YarisWorld
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.