 |
 |
|
|
10-27-2013, 11:00 PM
|
#1 |
 Drives: 2008 Yaris Join Date: Oct 2013
Location: Canada
Posts: 5
|
Remote starter install fail
I was installing an RS into a 2008 Yaris. I wired the two data wires wrong for the bypass and think I may have buggered the ECM. I hooked them into the diagnostic plug by mistake and not the 7 pin plug by the ignition. The result now is no voltage showing at the yellow constant power wire at the ignition. The car starts with the key,but with no heater fan or radio. What have I done?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compilation of Yaris How-tos/DIYs | YarisBueller | DIY / Maintenance / Service | 39 | 04-28-2018 09:47 AM |
| Remote Starter - Tail Light Problem | Chrsto4 | General Yaris / Vitz Discussion | 4 | 11-01-2009 12:36 AM |
| Remote Starter | Mistry | In Car Entertainment + Electronics (audio / video / alarm) | 1 | 09-14-2009 02:32 AM |
| can we install a remote starter? | krazyace1985 | In Car Entertainment + Electronics (audio / video / alarm) | 1 | 07-03-2009 01:15 AM |
| Installing a remote starter without cutting factory wires? | yaris08ce | In Car Entertainment + Electronics (audio / video / alarm) | 36 | 04-23-2009 09:59 PM |
Threaded Mode