 |
 |
|
|
04-05-2014, 06:16 PM
|
#1 |
|
Embracing Curves
Drives: '14 Prius Executive Join Date: Aug 2013
Location: mid-western Germany
Posts: 256
|
Brake symbol turns off delayed after engine start
Hi,
I recently noticed the brake symbol turning off with a short delay when I start the engine. It's about 1...2 seconds, but no longer than PS, ABS etc. stay on. Is there an issue about to come or can I let my diag interface stay where it is? 
|
|
|
|
04-05-2014, 07:03 PM
|
#2 |
|
It's the illusion you see
Drives: 07 Yaris Sedan Aero Join Date: Oct 2006
Location: Brossard, QC
Posts: 3,888
|
Brake symbol should turn on and off with your handbrake.
__________________
|
|
|
|
|
04-05-2014, 08:32 PM
|
#3 |
 ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
On Yaris with ABS, the brake light is an indicator for the ebrake as well as a secondary warning light for the ABS. I found this out experimenting with clusters. If you install an ABS equipped cluster in a non-ABS Yaris the brake light stays on.
__________________
|
|
|
|
|
04-05-2014, 08:57 PM
|
#4 | |
|
Embracing Curves
Drives: '14 Prius Executive Join Date: Aug 2013
Location: mid-western Germany
Posts: 256
|
Quote:
However, I wondered why it was on while the brake wasn't engaged 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Yaris Performance Primer | eTiMaGo | Performance Modifications | 31 | 10-20-2025 10:08 AM |
| Engine Slow to Start | ruimond | DIY / Maintenance / Service | 26 | 04-24-2021 03:37 PM |
| DIY: Intake Installation | redyaris | DIY / Maintenance / Service | 53 | 08-23-2014 06:34 AM |
| Engine dress up - brake fluid resivoire cap? | YarisSedan | Cosmetic Modifications (Exterior/Interior) | 5 | 11-15-2008 08:59 AM |
Linear Mode
