Single 10" Sealed Box - BIRCH baffle!

[spkrman]

The box itself comes with binding posts, and 14ga (or 12ga?) wiring pre-run. The interior is coated, it is glued and screwed. The panel the woofer mounts to is quality Birch ply (the $70 a sheet stuff!) that is stained with... the name of the stain escapes me... and varnished. Birch is *extremely* strong and holds screws extremely well, it is more comparable to a double layer (1.5") MDF baffle. The rest of the box is MDF.

There is gasket caulk around the woofer hole to ensure a 100% seal around the woofer. There are no leaks in this box.

It is approx 1.15 cube, which is perfect for most 10" woofers. If your not sure, ask me and I'll let you know if your woofer will fit.

www.spkrman.com for previous work.



Asking $125 shipped to the continental US, $160 shipped with the woofer.

This is a test box that I built from smaller piece of scrap I had laying around (hence the birch baffle), and it was used temporarily in my yaris just to have a little bump.

thx for lookin

Edit: This box will work in nearly any car, and fits in the LB firing back, up, sideways etc. The dimensions are 12 1/8 x 12 1/8 x 13 5/8.

[spkrman]

pic in the yaris:

[spkrman]

brain fart....

.75 cubes

[spkrman]

up for offers :)

[spkrman]

Bump for $85 shipped