 |
 |
|
|
12-06-2008, 03:01 PM
|
#1 |
  
Drives: '08 Bayou Blue LB AT Join Date: Oct 2008
Location: West Hills, CA
Posts: 2,517
|
How did you run the wideband A/F cable into the car?
I just got a wideband A/F gauge and the sensor unit needs about a 1 inch hole to feed through. The other end is a rectangular plug and needs a 1 1/4" square hole.
I figured the 1" hole would be easer. I'll be getting a bung welded to my midpipe right after the Megan header. The exterior cable with the two ends mentioned above is only about a foot long. Is there a large enough feedthrough that exists or did you guys drill new holes into the car? TIA
__________________
aFe Intake | Blitz Supercharger | Megan Header | TRD Exhaust | NST Pulley Set TRD Shocks/Struts | Tanabe NF210 Springs | TRD Sway Bar | Motegi TRAKLITE wheels | Kuhmo Ecsta XS R1 Concepts slotted rotors | Carbotech 1521 brake pads | stainless steel brake lines | Seibon vented carbon fiber hood |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| big older car vs little newer car | xed | General Yaris / Vitz Discussion | 9 | 09-16-2007 05:35 AM |
| New Siphon Mag: Yaris vs. xA vs. Versa vs. Fit @ Streets of Willow | Ran Kizama | General Yaris / Vitz Discussion | 9 | 06-18-2007 01:42 AM |
| where to run amp positive cable??? | punch | In Car Entertainment + Electronics (audio / video / alarm) | 8 | 12-21-2006 08:50 PM |
| Harman Kardon Drive + Play for IPOD | sroberts | In Car Entertainment + Electronics (audio / video / alarm) | 5 | 07-01-2006 02:05 PM |
| Buying a first car..lol | Blenjar | Off-topic / Other Cars / Everything else Discussions | 11 | 06-14-2006 12:58 AM |
Threaded Mode