 |
 |
|
|
03-26-2010, 10:01 AM
|
#1 |
 Drives: 2007 MX5 Join Date: Feb 2009
Location: Miami, Fl.
Posts: 338
|
Smart peoples....look here...intake help
I bought and am awaiting shipment of a bomz(fake aem) intake. But I am looking to modify it.
The intake is 2.25" all the way through....My idea is to cut the intake right after the bracket that holds it to the car and open it up to 3" to install this... http://hybridr.com/images/ebay/descr...lter-Combo.jpg or this.... http://www.bpinitiatives.com/assemblies.php From going to 3" to 2.25" what are the negatives and positives in doing this reduction on the intake. I know the reduction will increase the preasure throught the intake. Is that good or bad? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Intake Installation | redyaris | DIY / Maintenance / Service | 53 | 08-23-2014 06:34 AM |
| The great intake debate! | fmicle | General Yaris / Vitz Discussion | 74 | 10-07-2009 12:37 AM |
| MY new PRM Intake... | marcus | Performance Modifications | 27 | 05-04-2009 12:04 AM |
| Bomz Ebay Intake - Partial Review | Split | Performance Modifications | 11 | 11-19-2008 03:12 AM |
| Intake Systems Decision Maker.. | Blenjar | Performance Modifications | 25 | 09-15-2007 11:07 PM |
Threaded Mode