|
|
09-10-2021, 10:50 AM | #1 |
Drives: 2008 Yaris Join Date: Sep 2021
Location: Hamilton, ON
Posts: 14
|
How do you properly tension your serpentine belt?
Replaced mine a few months ago as the original was squealing so loud it was waking the neighbours...
Tried my damnedest to apply tension to it while tightening the bolt on the generator and it still squeals a bit from time to time when I start it up. I assume I didn't apply enough tension? How do you do it properly? |
09-11-2021, 08:09 AM | #2 |
Drives: 2009 Base Hatch 2 Dr Auto Join Date: Dec 2008
Location: nj
Posts: 4,790
|
It’s a little tricky as there’s no tension adjuster. I just keep trying until it doesn’t squeal. But there’s a caveat. Put too much tension on it and it might damage the water pump. That’s one thing Yaris Suffers from one and 100 have bad water pump prematurely.
So maybe a little squeal is OK?
__________________
Synthetic Oil: Its All In Your Head |
09-11-2021, 08:10 AM | #3 |
Drives: 2009 Base Hatch 2 Dr Auto Join Date: Dec 2008
Location: nj
Posts: 4,790
|
One thing I forgot to mention. I would only use a dealer supplied belt. They might be expensive but they last a long time.
__________________
Synthetic Oil: Its All In Your Head |
09-11-2021, 08:22 AM | #4 |
Drives: 2009 Base Hatch 2 Dr Auto Join Date: Dec 2008
Location: nj
Posts: 4,790
|
Careful when tightening and loosening the alternator bolt. A camshaft sensor is near one of them. It’s plastic and easily damaged!
__________________
Synthetic Oil: Its All In Your Head |
09-11-2021, 09:56 AM | #5 |
Drives: 2008 Yaris Join Date: Sep 2021
Location: Hamilton, ON
Posts: 14
|
Thanks again, Bronsin!
I think I'll leave it as is then as there is hardly any squeal at all now. |
09-13-2021, 07:36 AM | #6 |
Drives: No longer own a yaris :( Join Date: Mar 2012
Location: Ashland, VA
Posts: 680
|
I usually adjusted mine during the spring and fall. Otherwise it seems like the change in temperature and/or humidity would cause it to start squealing. Not sure if it was making the belt stretch/shrink/etc...but the first time I did it my bolts were almost impossible to break free.
__________________
I'm a hermit named Lee |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Determining proper tension for new serpentine belt | RMcG | DIY / Maintenance / Service | 11 | 12-30-2021 06:01 AM |
Serpentine belt tension questions | Rob888 | DIY / Maintenance / Service | 8 | 09-13-2020 08:51 PM |
Which serpentine belt? | courtartanis | DIY / Maintenance / Service | 0 | 11-30-2017 10:32 AM |
Squeal from Engine after replacing Water Pump and Serpentine Belt | vidfan | DIY / Maintenance / Service | 7 | 06-24-2014 10:41 AM |
Lost Serpentine Belt | NickNickNick | DIY / Maintenance / Service | 33 | 07-31-2011 12:28 PM |