![]() |
![]()
![]() |
|
![]() |
#1 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Hi everyone, I need your help, can you please click on the link http://www.theage.com.au/victoria/ap...j8ht.html#poll and vote "NO".
It would be a real help to me if you could spare the few seconds it will take to vote. Thanks for your support ![]() Oh and no there is no poll in this thread, it's on the linked page. Also the poll won't appear on a cell phone so please vote via pc.
__________________
![]() ![]() "Manual labour is not for me. In fact i'm not even sure non manual work is either." -Anthony Linton Check out ▬▬► I like I like ◄▬▬ for more fun on Facebook |
![]() |
![]() |
#2 |
vroom vroom
Drives: lil red 5-door Join Date: Sep 2006
Location: Bangkok, Thailand
Posts: 7,744
|
we need some "before" pictures before we can form an opinion ;)
__________________
The price of freedom of religion, or of speech, or of the press, is that we must put up with a good deal of rubbish. - Robert Jackson ![]() Bye bye 1NZ... |
![]() |
![]() |
#3 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() |
Thomas. Thanks for your support. But all I need is a "NO" vote. Not a subjective opinion.
__________________
![]() ![]() "Manual labour is not for me. In fact i'm not even sure non manual work is either." -Anthony Linton Check out ▬▬► I like I like ◄▬▬ for more fun on Facebook |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Urgent advise Needed MT Clutch & Bearing Spec. | victorddr | DIY / Maintenance / Service | 4 | 04-23-2011 10:27 AM |
URGENT Advice Needed! Relating to Power Steering, Alternator and Electrical. | The Marshall | General Yaris / Vitz Discussion | 25 | 10-21-2010 08:23 PM |
03 Yaris 1.0 VVti Engine Swap, URGENT help needed. | philwept_33 | DIY / Maintenance / Service | 1 | 05-15-2009 12:15 PM |
URGENT help needed :( -DIY springs | Masteraal | DIY / Maintenance / Service | 19 | 12-23-2008 03:23 AM |
how can u test a sub? URGENT | Sway84 | In Car Entertainment + Electronics (audio / video / alarm) | 10 | 07-09-2007 02:16 PM |