09 Fog Light Install - Toyota Yaris Forums

MGargano · 05-12-2009, 08:33 PM

I just want to make sure I'm doing this right before I finish so I don't have to tear everything apart again. I'm installing Micro Image fogs ( http://shop.microimageonline.com/pro...&productId=103 ) in an 09 LB and will be using the OEM stalk, not the supplied switch. I followed the supplied Toyota installation manual and I think I have a bit of a problem. Step #12 shows 2 wires (red/brown & red/white) connecting to pins 1 & 2 in the fuse panel but.... the wiring harness I received has 2 solid red wires. Does it matter which wires goes to which pin?

I used the headlight ground (near the air cleaner assembly) to ground the fogs and plugged in the supplied relay under the dash. Am I correct in assuming all that's left for me to do is install the OEM stalk? No more wiring necessary?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY (08' USDM Liftback): ESUSE Fog Light Install v2.0	goku87	DIY / Maintenance / Service	127	02-19-2023 08:01 PM
Compilation of Yaris How-tos/DIYs	YarisBueller	DIY / Maintenance / Service	39	04-28-2018 09:47 AM
Part #s for Fog Light install? Can anyone who works for Toyota confirm?	IsLNdbOi	Cosmetic Modifications (Exterior/Interior)	73	12-23-2010 06:15 PM
Fog light install	07yaris_fe	Cosmetic Modifications (Exterior/Interior)	10	07-20-2010 02:18 PM
Looking for the Toyota Fog Light install	RocknRollRon	DIY / Maintenance / Service	33	06-13-2010 07:46 PM

05-12-2009, 08:33 PM	#1
MGargano Drives: 2009 Yaris Hatchback Join Date: Feb 2009 Location: NJ Posts: 792	09 Fog Light Install I just want to make sure I'm doing this right before I finish so I don't have to tear everything apart again. I'm installing Micro Image fogs ( http://shop.microimageonline.com/pro...&productId=103 ) in an 09 LB and will be using the OEM stalk, not the supplied switch. I followed the supplied Toyota installation manual and I think I have a bit of a problem. Step #12 shows 2 wires (red/brown & red/white) connecting to pins 1 & 2 in the fuse panel but.... the wiring harness I received has 2 solid red wires. Does it matter which wires goes to which pin? I used the headlight ground (near the air cleaner assembly) to ground the fogs and plugged in the supplied relay under the dash. Am I correct in assuming all that's left for me to do is install the OEM stalk? No more wiring necessary?