 |
 |
|
|
08-23-2010, 03:25 PM
|
#11 |
  
Drives: Vitz RS Turbo Join Date: Nov 2008
Location: ML
Posts: 577
|
Today changed engine oil and coolant and installed the "NEW" Teflon braided pipe for the turbo water line. Also all in cabin wiring is finished and arranged it like it never been there
 . During the turbo water line installation I came to notice that the idle control on the throttle body has the coolant pipes missing (In and Out). Then I understood that these were being used to feed coolant to the turbo from the beginning. So I ask are these essentially needed for the idle control to work fine also since I changed the engine management? What are the consequences of these removed? Also I need to know some information on the Idle control like frequency and normal operating conditions. I attached a screenshot of the page of the ecu software to set this up |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor Longevity | Pavel Olavich | DIY / Maintenance / Service | 10 | 03-17-2012 12:43 PM |
| cali yaris built motor | cali yaris | Performance Modifications | 83 | 09-04-2009 12:08 AM |
| Fan motor noise... | 500snakz | General Yaris / Vitz Discussion | 10 | 12-01-2008 03:43 AM |
| Motor oil debate - interesting info but a long read. | mikeukrainetz | General Yaris / Vitz Discussion | 6 | 12-10-2006 09:16 PM |
| Exchanging Motor on a Liftback 1.3 Lt | weckjuan | Performance Modifications | 8 | 11-12-2006 11:58 AM |
Threaded Mode