|
10-25-2014, 12:58 PM | #1 |
If Its Not Blown It Sucks
|
Engine Rock and Roll.
So I think I've wrecked my motor mounts. I have to admit, since I've installed my Blitz (Thanks again Tolmach, CTScott, and Cali Yaris), I have developed even more of a lead foot. Do the factory motor mounts allow the engine to move fore and aft quite a bit (2-3")? If so, is there a solution to tighten them up a bit? If not, are there replacements that are stiffer but not solid? I've been tempted to take them off and re-bush them with polyurethane as well. Any thoughts on that route? |
Thread Tools | |
Display Modes | |
|
|