heres my short shifter mod!

[marcus]

took me a while to get this done but here it is. to begin with it was a b%tch to swap the short shifter..its not as easy as what twm shows on their steps then again the case may be slightly diferent from us version..

*shifter shaft bought from whoopee. thanks
-i had it bend at work and cut it down 2.9 inch lower than stock and had it rewelded added grooves b4 weld for extra strength.

*leather boot is from redline. although it should come with a bezel around the edges to give it that clean look..i instead glued the edges to the boot itself to keep it clean.

*push washer courtesy of twm.. thanks to frank!
- the washer has to be dremelled cut otherwise another bit*h to take out

*quickshifter added courtesy of nst! thanks

the install 1 out of ten being ten the hardest ill give it an 8.. took 2 people to do this. and i have to take the whole plastic case out to get underneath to remove the plastic top holding the shaft. i wish i took photos but it was snowing at the same time.. sorry.