TACH-cluster replacement-resetting ODO?

[ricepower]

Originally Posted by darkMINI

Before you swapped the ECU was it just the Tach dial and pointer not illuminating, or both the Speedo and Tach dials/pointers?

after the swap, the gauge backlight, pointers(tach+speedo) is not working..Rest of the functions is working.

Below my observation:

My wiring harness is not the same. The canadian cluster has the illumination control and GCC/EU model don't have. To fix this, You have to swap/jumper or rig the illumination pinout of the new cluster.

I put it back my original cluster as I am annoyed without the illumination/backlight. Everything works fine. From here, I noticed also that they have different programming cluster daughter board. Tried to swap their daughter boards also but the results is more bad(none of the pointers is working).