FS: DIY Cruise Control Pin Kits

[CTScott]

Originally Posted by hayden

I'm a little lost on this. I have an 07 3DR auto with no power options.

One of the wires goes from A21-pin 40 to pin 1 of D3. I haven't cracked it open to look yet, but I'm guessing this takes two of the three wires supplied (with a connector somewhere between the two)?

And I'm guessing I attach the wire that plugs into pin 2 of D3 to a ground point?

Correct - The one with the seal goes into A21 and the other two go into D3. One of the D3 pins connects to the A21 pin (you'll need to run a wire {18-22 AWG} between them). The other gets connected to a ground point under the dash.