 |
 |
|
|
11-08-2011, 01:04 PM
|
#1 |
 Drives: 2015 H Production Yaris Join Date: Oct 2009
Location: Debary, FL
Posts: 1,953
|
tire fitment
Its going to start sooner or later, so I thought I would share what we found...
The 2012's rear fenders seem to be just a bit tighter than the previous gen. This car is fitted with a 15x7 +35mm offset wheel, wrapped in a 205-50-15, drop is 2.5". The rear tires rub - the car valet at SEMA applied so much tire dressing you cant see the marks in the sidewalls that were made moving the car out of my driveway, but it does rub. If the rear fenders were rolled they should easily clear the tires, or run a +38 or bigger (numerically) offset wheel. With -camber in the front there are no interference issues. 
__________________
2005-2008 SCCA Solo BS National Champion 2017-2018 SCCA H Prod National Champion 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NITROGEN GAS TIRE FILL: WORTH IT? | EjDaPogi | Middle East | 15 | 03-20-2011 02:06 AM |
| Tire rotation: Does TPMS recognize tire position? | jcdrotos | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 17 | 03-17-2011 02:00 PM |
| snow tire fitment? | Phaeton | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 5 | 12-05-2008 06:20 PM |
| Tire Fitment question | Ryu | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 5 | 01-14-2007 01:47 AM |
| The Tire inflation debate... | Tankota | General Yaris / Vitz Discussion | 20 | 06-01-2006 07:09 PM |
Threaded Mode