Toyota Recalls

[ciscobear]

Originally Posted by GianniVRS

Does this (Window switch problem) concern the JDM version VITZ or just the EU / USA markets?

Recall of six models Vitz and Belta Notification number 3036
, October 11 start date recall

For the vehicle part of the six models Vitz and Belta, I reported to the Ministry of Land, Infrastructure and Transport following the recall of content on 10 October 2012.

Illustration where improvement

One. Status of the problem
Some of the power window switch on the driver's door, grease for lubrication of the switch is not uniformly applied, that the lubricity is deteriorated grease is carbonized by (spark) arc generated in the contact portion at the time of switch operation have. Therefore, there is a possibility that the sliding switch is deteriorated, and the contact malfunction worn early.
Further, when applied to a commercial lubricant like trying to improve the sliding switch failure may cause the switch to melting.
2. The contents of improvement
And replace it with a switch board coated with a heat-resisting grease, about what to check all vehicles, the power window switches, malfunction is confirmed, but otherwise, grease the heat resistance at the contact.
Also, about what the inspection above, was applied to the heat-resistant grease, Then, if malfunction occurs, we replace the power window switch.

http://toyota.jp/recall/2012/1010_4.html

Check the page to see if your car is affected.