 |
 |
|
|
11-13-2012, 11:38 AM
|
#4 |
|
Asshole
Drives: 2012 and 2013! Join Date: Aug 2012
Location: Your moms house.
Posts: 392
|
I can't help you with that specifically.
But for others doing this, the ball joint will separate with just a rap with a hammer, on the outside of the knuckle, where the ball joint stud goes through. Its not pressed, it's an interference fit. The vibration from the impact will loosen the stud. Same goes for tie rod ends.
__________________
Cheapest DD I could find!! 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cruise control install 2009 Yaris 3 door | PeteZNY | DIY / Maintenance / Service | 125 | 03-31-2024 10:22 AM |
| DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag | CTScott | DIY / Maintenance / Service | 307 | 04-04-2023 04:43 AM |
| Cruise Control - Again! | CB900F2 | DIY / Maintenance / Service | 47 | 06-17-2010 07:29 PM |
| Cruise control vs MPG | YarisOwnersDad | Fuel Economy Forum | 15 | 05-29-2009 04:55 PM |
| Are the optional airbags worth it ? | avenno2g7 | General Yaris / Vitz Discussion | 46 | 12-07-2008 03:40 AM |
Threaded Mode