ABS and "!" lights are ON again! - Toyota Yaris Forums

invisibleghosts · 07-03-2013, 09:39 PM

First off let me thank everyone for posting such good information on checking, preventing and replacing in all of the above posts!

I've followed the instructions and have removed both sensors, the first was dirty, but intact, the second....not so lucky.

So I managed to switch out the old, broken, wiring and sensor (I'll call the male end) but I'm a bit lost on the other side (female) end. I had a few pins that were broken off (tons of sand/salt/snow in Winnipeg) and I'm not sure what part or process to use to replace the "female" side? I wasn't able to find anything mentioned in the previous posts on a DIY...any advice?

I've been taking photos as I've gone along and I hope to post them all once I've completely finished to help others. I'll admit I'm not very handy, but I'd rather not pay the dealership for a job that I can do myself!

07-03-2013, 09:39 PM	#11
invisibleghosts I've made a post! Drives: 2008 Yaris Join Date: Jul 2013 Location: Winnipeg Posts: 1	ABA wiring sensor replaced First off let me thank everyone for posting such good information on checking, preventing and replacing in all of the above posts! I've followed the instructions and have removed both sensors, the first was dirty, but intact, the second....not so lucky. So I managed to switch out the old, broken, wiring and sensor (I'll call the male end) but I'm a bit lost on the other side (female) end. I had a few pins that were broken off (tons of sand/salt/snow in Winnipeg) and I'm not sure what part or process to use to replace the "female" side? I wasn't able to find anything mentioned in the previous posts on a DIY...any advice? I've been taking photos as I've gone along and I hope to post them all once I've completely finished to help others. I'll admit I'm not very handy, but I'd rather not pay the dealership for a job that I can do myself!