 |
 |
|
|
01-20-2015, 09:19 PM
|
#11 |
  Drives: 2011 Toyota Yaris Join Date: Feb 2013
Location: Cali
Posts: 725
|
Would anyone happen to know if I can use 65mm ID coil springs on my fronts if my Megan coils use 62mm ID coil springs? I know the rear doesn't matter as much since it should work as long as it fits on the perch/locking rings (If I end up using the locking rings), but I know in the front it'll go over the strut and locking rings.
EDIT: Nevermind, just going to suck it up and save for Swift springs. I WAS looking for a cheaper alternative, but hey, there's a reason why they're so expensive. Plus, I know the Swift springs work really well with Megan coilovers (via the internet) haha. Last edited by TerenceCruz; 01-20-2015 at 09:50 PM. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2010 Vitz RS Modellista Completed Car | Vitz Rs Modellista | Photo-Video-Media Gallery | 38 | 11-18-2014 01:25 PM |
| 2012 Vitz from the 2011 Tokyo Auto Salon | CTScott | Third Gen Yaris General Discussion | 14 | 02-10-2011 09:06 AM |
| Is UA-NCP13 1.5L Manual Trans a Vitz RS? | WesSunday | General Yaris / Vitz Discussion | 1 | 11-28-2010 11:47 AM |
| Newly refreshed 2011 Toyota Corolla | Kal-El | Off-topic / Other Cars / Everything else Discussions | 23 | 11-27-2010 01:57 PM |
| A German Yaris/Vitz/Echo ;) | we-to-11 | Photo-Video-Media Gallery | 5 | 06-27-2007 09:26 PM |
Threaded Mode