|
05-19-2015, 12:25 PM | #1 |
Drives: 2007 Yaris LB Join Date: Aug 2009
Location: Bolivar
Posts: 13
|
Serpentine Belt Replacement - Is it possible to get it too tight?
I'm about to replace the serpentine belt on my 2007 Yaris. From reading around on here, I see that if it squeals, it's too loose. However, would a belt that's too tight put bad pressure on the pulleys?
Since nobody seems to be mentioning a too-tight belt, I'm thinking that it's probably difficult to get it too tight. Thoughts?
__________________
Keith, 2007 Yaris Liftback YouTube: Keith's Test Garage | http://www.KeithsTestGarage.com |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Serpentine belt squeals on cold start up after replacement. | YarYarBinks | DIY / Maintenance / Service | 16 | 03-03-2017 10:04 AM |
Serpentine belt replacement. | Phaeton | DIY / Maintenance / Service | 4 | 01-10-2016 07:58 AM |
Serpentine belt replacement - dumb question | JSCIII | DIY / Maintenance / Service | 1 | 04-28-2015 05:55 PM |
Drive Belt Replacement | wagon | DIY / Maintenance / Service | 2 | 12-28-2014 11:24 AM |
drive belt replacement and/or water pump replacement | sociolog | DIY / Maintenance / Service | 9 | 02-10-2014 12:33 PM |