Connect mono amp. + subwoofer to stock HU?

[eii]

Originally Posted by IsLNdbOi

Anyone else have ideas on how to connect the LOC w/o tapping into, cutting or splicing the stock wiring?

Well isnt that the whole point of a LOC is so you can tap the existing wire? You can find exposed wires and 'twist' them and pray for the best, though the connections will be weak and so your sub wont sound so good. If it works ok, those connections will most likely losen over time. Its easier if you just work with the harness and tap the wires from there. If you dont wanna cut, splice, solder, tap the wires your only otherway would be to buy a HU with RCA outputs.

BTW battleversiontc, were you the one helping me with LOC pre-hax?

I'm not an expert, but I did what battleversiontc mention in THIS thread and it worked out for me.

[battleversiontc]

Originally Posted by eii

Well isnt that the whole point of a LOC is so you can tap the existing wire? You can find exposed wires and 'twist' them and pray for the best, though the connections will be weak and so your sub wont sound so good. If it works ok, those connections will most likely losen over time. Its easier if you just work with the harness and tap the wires from there. If you dont wanna cut, splice, solder, tap the wires your only otherway would be to buy a HU with RCA outputs.

BTW battleversiontc, were you the one helping me with LOC pre-hax?

I'm not an expert, but I did what battleversiontc mention in THIS thread and it worked out for me.

i think so

yeah you can do that to if your trying to keep your wires from being tapped into