Here is the best place to buy tools for all your DIYers

[Altitude]

Originally Posted by Tamago

you had to use a press to get u joints out? i just use a hammer and punch 1310 joints in and out in 3 minutes

oh and i bought an aluminum racing jack at HF. 4 years of serious abuse (used at every autocross to swap wheels out) and it's just starting to leak. i'm gonna pull it apart and re-seal it shortly and back in business. best $90 i've ever spent, no more scissor jack lol

It was a last resort. I tried hammer and punch, sockets, heating, solvents even a ball joint press - those bastards were practically welded in. The hydraulic punched them right out and it sounded like a shotgun going off when they let go.

[Tamago]

Originally Posted by Altitude

It was a last resort. I tried hammer and punch, sockets, heating, solvents even a ball joint press - those bastards were practically welded in. The hydraulic punched them right out and it sounded like a shotgun going off when they let go.

been there done that.. i use an air over oil press to knock out the chevy (teflon) joints. other than that it's BFH and punch all the way.

(btw if you need custom driveshaft work PM me)