Info Needed for Installing an Amplifier - Toyota Yaris Forums

ozmdd · 05-01-2009, 07:35 PM

You should look up the wiring color codes in the DIY's, and that will tell you how to get amp power and on/off switching. Battery access is easy through any one of several grommets on the firewall, or drill-and-fill. How are you planning to get signal to your amp? The factory HU has no RCA-outs. Running the wire to the rear sub is easy: remove each of the trim panels from the passenger side kick panel to the rear hatch and tuck your wire in the nice little pink wire holders. The wires can then run out into the spare tire well and up to your sub. You can also tuck the wire under the rear side panel if you don't want to remove it, but its easy to remove any panel in this car since they are all snap-fit. Just work slowly and take a look at the snap diagrams before you start pulling on shit. The door sill just pulls right off.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PINOUT info stereo	ozmdd	In Car Entertainment + Electronics (audio / video / alarm)	5	12-14-2009 08:52 AM
DIY needed for amplifier for sedan install	YarisSedan	In Car Entertainment + Electronics (audio / video / alarm)	2	02-27-2009 11:07 PM
Dealer(s) told me they needed to run my credit report even though I'm...	firebird1999us	New YARIS Purchase Forum	32	02-10-2009 11:08 PM
urgent info needed..(before going shopping)	seanele	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	9	07-02-2007 11:07 PM
Motor oil debate - interesting info but a long read.	mikeukrainetz	General Yaris / Vitz Discussion	6	12-10-2006 09:16 PM

05-01-2009, 07:35 PM	#2
ozmdd Reluctantly Crouched... Drives: 2008 Yaris HB M/T Join Date: Oct 2008 Location: DFW, TX Posts: 867	You should look up the wiring color codes in the DIY's, and that will tell you how to get amp power and on/off switching. Battery access is easy through any one of several grommets on the firewall, or drill-and-fill. How are you planning to get signal to your amp? The factory HU has no RCA-outs. Running the wire to the rear sub is easy: remove each of the trim panels from the passenger side kick panel to the rear hatch and tuck your wire in the nice little pink wire holders. The wires can then run out into the spare tire well and up to your sub. You can also tuck the wire under the rear side panel if you don't want to remove it, but its easy to remove any panel in this car since they are all snap-fit. Just work slowly and take a look at the snap diagrams before you start pulling on shit. The door sill just pulls right off.