Can we do this? (aka The DIY Cruise Control Thread)

[nickhjort]

Pics for now... I will take more in an hour or so when I get it put in...it's raining like a mofo here now...


This is my switch I bought at radio shack. You get four in a pack for 3.59 I think.


Aluminum bracket, switch and bolt that replaces stock clutch switch.


My Frankenstein (It's ALIIIIIIVE!!!!...almost)





Just make sure you have a SPST switch that is normally open...not closed. Also make sure it is long enough to touch the little black plate you see in the picture. I think mine is barely gunna work. If not I will probably epoxy something onto the end to make the button part longer. We'll see in a few.

[nickhjort]

Well the switch was just barely too small. So JB Weld time...




I used a cap from a can of liguid wrench :) Now it truly is a frankenstein haha. But it's all good. Nobody can even see it unless they stick their head under the dash. Anyway more pics to come soon when it's installed in the car.

[nickhjort]

Alright peeps, it's in. It works so far when hooked up to the meter. Tomorrow I'm gunna wire it in and test her out. Now all I'm waiting for is the led "module", courtesy of CTScott then I'll be all set