Group Buy - True Double Din Radio Trim for Liftbacks (180mm opening)

[IsLNdbOi]

Originally Posted by WeeYari

This pic should work for now.

It may have been blind luck that I was able to achieve the exact amount of movement required for my JVC HU.

So the way you mounted it, the HU is attached to each bracket with only one screw?

[WeeYari]

Originally Posted by IsLNdbOi

So the way you mounted it, the HU is attached to each bracket with only one screw?

No, 2 screws in each bracket.

[Adriaan]

Received it two days ago but doesn't work with my two single din setup. The radio & the bottom cover pocket are 182mm. I could cut the plastic to get the radio to open but as in the picture, the bottom cover is wider so that wouldn't open. So now I may have to get rid off it, if i can't think of anything after the weekend its gone. I wanted one so badly and i can't use it now. Here a pic of my setup so if anyone else has the same the 180mm radio trim wouldn't work.

[CTScott]

Originally Posted by Adriaan

Received it two days ago but doesn't work with my two single din setup. The radio & the bottom cover pocket are 182mm. I could cut the plastic to get the radio to open but as in the picture, the bottom cover is wider so that wouldn't open. So now I may have to get rid off it, if i can't think of anything after the weekend its gone. I wanted one so badly and i can't use it now. Here a pic of my setup so if anyone else has the same the 180mm radio trim wouldn't work.

How about pushing the headunit in deeper, per WeeYari's instructions above? The HU should work that way. The question is if the door on the pocket will fit within the trim.