 |
 |
|
|
03-05-2010, 12:20 PM
|
#31 |
  
Drives: 09 Yaris HB, 08 SR5 Tundra Join Date: Jan 2009
Location: RGV, Texas
Posts: 1,086
|
actually to be more accurate this is what the article said...
"Increasing the angle of a car's hood by propping it at the rear isn't always beneficial in and of itself, but decreasing the angle at which it meets the windshield, while covering the wipers, helps cut drag." anyway it's a pretty interesting article full of mods to decrease drag. so i'm sure doing this one mod alone won't do much but that's kinda the way it goes with all modifications to some degree.
__________________
 I crush you like tiny clown car, because you are clown, yes? |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C-One Replica Hood. Lets Fix this sucker! | TinyGiant | Cosmetic Modifications (Exterior/Interior) | 56 | 11-10-2009 12:31 AM |
| Micro Image Hood Design Contest | cali yaris | Micro Image | 209 | 10-04-2009 03:49 AM |
| Installed 10mm PG spacers on a 15x7 +25 wheel | kngrsll | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 12 | 08-27-2009 08:10 PM |
| Installed hood deflector, in-channel vent visors and hood seal. | IsLNdbOi | Cosmetic Modifications (Exterior/Interior) | 16 | 12-20-2008 09:36 AM |
| Before you buy . . . check that hood! | woof | General Yaris / Vitz Discussion | 4 | 12-02-2006 06:14 PM |
Threaded Mode