Fog light question

[CTScott]

If you have the OEM ones where you have the fog light switch as part of the headlight stalk then do the following to allow them to come one with either the high or low beams:

Take the wire that is in pin 4 of the headlight stalk (it will be orange, beige or white, depending on year and if you have DRLs) and cut it (leave yourself some room on either side of the cut to be able to work with the wire.

Take the harness side of the cut wire and cap it off.

Take the connector side of the wire and tap it to the white wire in pin 13.


D4 - Wires.jpg

[big lo]

Originally Posted by CTScott

If you have the OEM ones where you have the fog light switch as part of the headlight stalk then do the following to allow them to come one with either the high or low beams:

Take the wire that is in pin 4 of the headlight stalk (it will be orange, beige or white, depending on year and if you have DRLs) and cut it (leave yourself some room on either side of the cut to be able to work with the wire.

Take the harness side of the cut wire and cap it off.

Take the connector side of the wire and tap it to the white wire in pin 13.


Attachment 34678

Thanks for the info, just to let you know my is the 2007 sedan S class. Now as for the harness thats located to the fuse box correct? The colors that are here is red, green, light green and two that are spaced with green and grey, so run that by me again please.

[CTScott]

Originally Posted by big lo

Thanks for the info, just to let you know my is the 2007 sedan S class. Now as for the harness thats located to the fuse box correct? The colors that are here is red, green, light green and two that are spaced with green and grey, so run that by me again please.

The connector pictured above is under the lower steering column cover on the left side, right at the base of the headlight switch.

[big lo]

Originally Posted by CTScott

The connector pictured above is under the lower steering column cover on the left side, right at the base of the headlight switch.

Good looking out CT that was very helpful, like I said I will post up the out come tonight, thanks you & Brian for being so supportive to my project. Holla at your boy.