Remote Start DIY Wiring Guide 2006-2010 Yaris

[CTScott]

Originally Posted by Skylinecar1982

Yeah I hooked up the brown for lock but no dice. But the bottom right wire (orange i believe) works but only for unlock.


And the factory keyless remote doesnt work when I start it just pulsing the wire manually

Thanks Mark

If the orange works for unlock, then the pink directly above the orange should work for lock.

I am not catching what you mean about the remote not working?

[Skylinecar1982]

Originally Posted by CTScott

If the orange works for unlock, then the pink directly above the orange should work for lock.

I am not catching what you mean about the remote not working?

Tried the pink too also no luck but will try again tomorrow.


I can take the green wire from the ultra start ( the wire that needs the negative pulse to start.) and I can manually ground the wire twice to make the remote start think it is getting a negative pulse. Then the device will start the car. Once the car is started through the device. The factory remote will not work anymore for the vehicle.

Thanks
Mark

[CTScott]

Originally Posted by Skylinecar1982

Tried the pink too also no luck but will try again tomorrow.


I can take the green wire from the ultra start ( the wire that needs the negative pulse to start.) and I can manually ground the wire twice to make the remote start think it is getting a negative pulse. Then the device will start the car. Once the car is started through the device. The factory remote will not work anymore for the vehicle.

Thanks
Mark

There are two pinks. Make sure that it's the large one on the end, not the small one in the middle.

[Skylinecar1982]

Originally Posted by CTScott

There are two pinks. Make sure that it's the large one on the end, not the small one in the middle.

Yeah that is the one that I tried but it was late in the day and I will try again tomorrow.

thank you
Mark

[CTScott]

Originally Posted by Skylinecar1982

Yeah that is the one that I tried but it was late in the day and I will try again tomorrow.

thank you
Mark

I just downloaded the manual for the 1155. They actually say to connect the pulse to start wire to the unlock rather than lock. They probably do that because of cars that have security that prevents them from starting unless the car was unlocked. That may be why your factory remote gets locked out after starting.

[Skylinecar1982]

Originally Posted by CTScott

I just downloaded the manual for the 1155. They actually say to connect the pulse to start wire to the unlock rather than lock. They probably do that because of cars that have security that prevents them from starting unless the car was unlocked. That may be why your factory remote gets locked out after starting.

Oh well I tried it on the lock and unlock wires on page 7 but nothing happened. But I did have it working with unlock using the thicker orange wire in the bottom right of the connector but , after it started the remote still wouldn't work. The doors where open but I wanted them to be closed so that I can start it and not have to watch it while it warms up.(security wise.)

[CTScott]

Originally Posted by Skylinecar1982

Oh well I tried it on the lock and unlock wires on page 7 but nothing happened. But I did have it working with unlock using the thicker orange wire in the bottom right of the connector but , after it started the remote still wouldn't work. The doors where open but I wanted them to be closed so that I can start it and not have to watch it while it warms up.(security wise.)

The 1155 has the option to relock after starting, so you could set it up to start on the double unlock pulse and then relock.