PETERPOOP's Turbo Build Thread. - Toyota Yaris Forums

Bluevitz-rs · 11-18-2010, 05:25 PM

So then, what's the point of putting a hole in the block so high? Why not just put it just below the level of the oil in the pan to begin with.

The laws of equalization should apply to any liquid fluid. No matter what the hight of the return line in the oil, the levels will always equalize out. Even if the return was taped underneath the pan. The whole problem with the Zage return was that is was too restrictive running it all the way to the front.

The return line on my old Greddy kit was in the back of the oil pan and I experienced no problems with it at all. But it ran straight out the bottom of the turbo and into the pan. No bends anywhere. (I can post a picture of it later...)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Zage Turbo Kit Install - Toyota Yaris	Focus_Sh1ft	Forced Induction Forum	160	02-06-2022 08:14 PM
Scion XB 1NZ-FE Turbo build	xbgod	Forced Induction Forum	417	07-24-2011 09:16 PM
XBG's Total Build and Update Thread	xbgod	Performance Modifications	10	11-18-2010 11:19 PM
Whats needed to turbo charge the yaris?	Arkhangel	Forced Induction Forum	44	03-02-2009 10:08 PM

11-18-2010, 05:25 PM	#11
Bluevitz-rs 1NZ-6spd View User's Garage Drives: '05 6-Spd Vitz RS Join Date: Oct 2008 Location: Oshawa, Ontario, Canada Posts: 2,967	So then, what's the point of putting a hole in the block so high? Why not just put it just below the level of the oil in the pan to begin with. The laws of equalization should apply to any liquid fluid. No matter what the hight of the return line in the oil, the levels will always equalize out. Even if the return was taped underneath the pan. The whole problem with the Zage return was that is was too restrictive running it all the way to the front. The return line on my old Greddy kit was in the back of the oil pan and I experienced no problems with it at all. But it ran straight out the bottom of the turbo and into the pan. No bends anywhere. (I can post a picture of it later...)