 |
 |
|
|
|
|
05-05-2011, 06:21 PM
|
#1 |
 
Drives: '08 LB MT Bayou Join Date: Oct 2008
Location: Colorado
Posts: 1,671
|
auxmike - Just curious as I'm guessing I'll run into this issue at some point too. Did you DIY and was it cramped getting the pump in and out? Doesn't appear to be whole lot of clearance in that area.
|
|
|
|
05-08-2011, 04:25 PM
|
#2 | |
Drives: 2008 HB, A/T, Power W/L/M Join Date: Oct 2008
Location: LI, New Yawk
Posts: 2,063
|
Quote:
In order to get the old pump out I had to put a 4ft. pry bar between the engine and the frame side. Then I pulled real hard as I slid out the pump. It did put 2 dents in one of the A/C tubes though. Rested the bar on the center bolt of the crank pulley. I did this because I did'nt want to start lowering the engine and causing more problems...
__________________
 Never take eyes off opponent - Bruce Lee |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
