Strut mount (bearing) cause camber to be off?

[CoryM]

Originally Posted by chaditotx

Just curious... I do know that the cap that went on top of the bearing got boogered a little when I was installing my springs. -1.5 camber on drivers side only. I guess this would be a good question for the auto x guys.

-1.5° camber is a far ways out of spec. What is the passenger side at? If you have the print-out that would help. Basically if you have more than 0.5° difference side to side you will notice a lead (unless caster cancels it out).
Define "boogered" as well.

Cheers.

[chaditotx]

Originally Posted by CoryM

-1.5° camber is a far ways out of spec. What is the passenger side at? If you have the print-out that would help. Basically if you have more than 0.5° difference side to side you will notice a lead (unless caster cancels it out).
Define "boogered" as well.

Cheers.

-1.5 drivers side, -8 passenger side. I have Sportline springs and 7" wide 17" rims, 38 offset. Last time it was aligned, it was fine. I just put tokico's on and replaced the strut bearings on both sides. Still same on camber. Starting to think stock control arm bushings are a little too stretched out on drivers side?