Warning - Broken control arm bolt! - Toyota Yaris Forums

Crazy Butcher · 01-24-2013, 06:34 PM

I get some rattling/creaking noise at about 1500k rpms to about 2k rpms, especially on the front driver side, could this be the cause of the rattling/creaking? as soon as i get over 2k-2.5k rmps it stops. it happens mostly when its cold outside. It also happens oftenly when i take off at lights and stops since i go back down to the 1.5k 2k rpms range.

CTScott · 01-24-2013, 06:40 PM

Quote:

Originally Posted by Crazy Butcher

I get some rattling/creaking noise at about 1500k rpms to about 2k rpms, especially on the front driver side, could this be the cause of the rattling/creaking? as soon as i get over 2k-2.5k rmps it stops. it happens mostly when its cold outside. It also happens oftenly when i take off at lights and stops since i go back down to the 1.5k 2k rpms range.

Possibly. Stick your hand down there and see if you feel the head of the bolt or if it is gone.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY Cruise Control FAQ (2006-2010 Yaris)	CTScott	DIY / Maintenance / Service	468	11-19-2024 03:45 PM
Cruise control install 2009 Yaris 3 door	PeteZNY	DIY / Maintenance / Service	125	03-31-2024 09:22 AM
DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag	CTScott	DIY / Maintenance / Service	307	04-04-2023 03:43 AM
Cruise Control - Again!	CB900F2	DIY / Maintenance / Service	47	06-17-2010 06:29 PM
Cruise control vs MPG	YarisOwnersDad	Fuel Economy Forum	15	05-29-2009 03:55 PM

01-24-2013, 06:34 PM	#1
Crazy Butcher Drives: Yaris 2008 Join Date: Jan 2012 Location: EmptyHell(mtl) Posts: 43	I get some rattling/creaking noise at about 1500k rpms to about 2k rpms, especially on the front driver side, could this be the cause of the rattling/creaking? as soon as i get over 2k-2.5k rmps it stops. it happens mostly when its cold outside. It also happens oftenly when i take off at lights and stops since i go back down to the 1.5k 2k rpms range.