Yet another Blitz Supercharger Install

[TOLMACH]

Question pls re wiring .. (I know I am very slow)

My question deals with clutch activation

1. I am right in thinking that blue wire on the diagram is simply supplying +12V signal to the relay (this wire goes from the 4-position module which manages the whole activatio thing)?

2. and that If I wire this unit only (wihtout connecting the fuel controller and 4-position module ) and supply +12 v to the blue wire I will be able to check whether clutch is engaging (just wanted to check the sc unit itself prior to installation as my kit is a pre-owned one)

Thank you

P.

[CTScott]

Originally Posted by TOLMACH

Question pls re wiring .. (I know I am very slow)

My question deals with clutch activation

1. I am right in thinking that blue wire on the diagram is simply supplying +12V signal to the relay (this wire goes from the 4-position module which manages the whole activatio thing)?

2. and that If I wire this unit only (wihtout connecting the fuel controller and 4-position module ) and supply +12 v to the blue wire I will be able to check whether clutch is engaging (just wanted to check the sc unit itself prior to installation as my kit is a pre-owned one)

Thank you

P.

The blue wire from the cabin switch is actually the switched ground for the relay coil. If you look at that diagram above you will see that fused power goes to the relay coil and then the blue wire from the switch goes to the other side.