transmission oil seal

[kc0rpm]

OK, looks can be deceiving. I am inclined to believe that you are correct and that part number is for an Xb as it is at least half an inch too small in diameter.

[CTScott]

Originally Posted by kc0rpm

OK, looks can be deceiving. I am inclined to believe that you are correct and that part number is for an Xb as it is at least half an inch too small in diameter.

It's absolutely amazing that finding a simple part could be so hard.

Does this look correct for the measurements?
Shaft Size: 1.378 in. (35 mm.)
Housing Bore: 2.48 in. (63 mm.)
Outside Diameter: 2.491 in. (63.28 mm.)
Width: 0.394 in. (10 mm.)

[kc0rpm]

Originally Posted by CTScott

It's absolutely amazing that finding a simple part could be so hard.

Yeah, no kidding. I was forced to put the old seal back in as I have to have the car back on the road. I'm just hoping it doesn't leak too bad as putting that old seal back in is probably the worst option. On another note I do have to say that royal purple gear oil is like night and day compared to the cheap stuff.