2007 sedan fuel pump not running and check engine light - Toyota Yaris Forums

Gander · 10-26-2014, 09:13 AM

I just stumbled up this thread as my wife's car is showing the same symptoms - cranks and doesn't start. I followed the instructions above and got the following:

Testing the coil of the c/opn relay on pins 4B-9 and 4E-5 with the ignition off got a resistance of 170ohms.

Checking across pins 4A-8 and 4B-11 with the ignition in the ON postion I found the voltage to be 0. If checking the same pins individually with the multimeter grounded on the chassis I found 12v at both pins.

I then shorted the 4A-8 and 4B-11 and when trying to start I could smell unburned fuel coming from the exhaust but it still wouldn't start.

Do you think I'm looking at a faulty ECM and do I read right that the relay is integral to is and cannot be replaced without replacing the ECM itself? If this is the case where would I find it to get a part number or can it be found from the VIN?

Many thanks for any help you can provide :-)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fuel filter replacement	jaimico	DIY / Maintenance / Service	43	03-07-2023 12:05 PM
*The Engine Oil Bible*	Hussain-Vtec	Performance Modifications	20	09-28-2016 03:47 PM
The Nitrous Thread	ChinoCharles	Performance Modifications	116	02-16-2016 04:07 PM
Car shuts off when A/C turned on...	Howster	DIY / Maintenance / Service	33	07-06-2013 06:00 PM

10-26-2014, 09:13 AM	#17
Gander I've made a post! Drives: 2009 Yaris VVTi Join Date: Oct 2014 Location: UK Posts: 1	I just stumbled up this thread as my wife's car is showing the same symptoms - cranks and doesn't start. I followed the instructions above and got the following: Testing the coil of the c/opn relay on pins 4B-9 and 4E-5 with the ignition off got a resistance of 170ohms. Checking across pins 4A-8 and 4B-11 with the ignition in the ON postion I found the voltage to be 0. If checking the same pins individually with the multimeter grounded on the chassis I found 12v at both pins. I then shorted the 4A-8 and 4B-11 and when trying to start I could smell unburned fuel coming from the exhaust but it still wouldn't start. Do you think I'm looking at a faulty ECM and do I read right that the relay is integral to is and cannot be replaced without replacing the ECM itself? If this is the case where would I find it to get a part number or can it be found from the VIN? Many thanks for any help you can provide :-)