My 2zrfe swap

[brushforhire]

Originally Posted by beaker

In all fairness to the header manufacturer on the fitment, we are trying to use a header/mid-pipe on a different car than what it was intended for. Doesn't look like any major fabrication to make it work. My only concern would be the flange for the muffler to mid-pipe. The slip joint on the mid-pipe is actually a good thing for this experiment, gives you a little more flexibility in fitment.

They had been advertising all over other forums and the internet that it is for the Yaris TS. So once I put the 2zrfe engine into my car, it is basically the same thing, so it should fit exactly the same.

That being said, I dunno if they actually sold a midpipe and header to any actual Yaris TS owners.

The slip joint isn't really needed honestly, but not really hurting anything either, I just like a sealed exhaust pipe.

In regards to the rear flange they told me most people are just using high temp silicone, which worries me. They are sending me a regular gasket that is supposed to work, so I will keep you all updated on that.